Home » Forums » Community Edition » Help

Active Channels...

intrinet
Posts: 20
 Member Since:
2007-07-18
Submitted by intrinet on Tue, 09/11/2007 - 12:38pm.

Should I be concerned that "Active Sip Channels:" displays 1 or 2 sometimes when nobody is on the phone? I turned on SIP debugging and when I run show SIP channels from the CLI I get this or some other similar information.(I don't know if this is helpful or not)

Peer User/ANR Call ID Seq (Tx/Rx) Form Hold Last Message
64.2.142.31 intrinet 5dabc0ce765 00109/00000 unkn No
1 active SIP channel
Verbosity is at least 1

Earlier today I got an error message "All circuits are busy" while trying to make a call, and then later when the call went through I got "all circuits are busy" in the middle of the phone call and got disconnected.

‹ Looking for advice Where can I download Trixbox 2.4 ›

&nbsp

intrinet
Posts: 20
 Member Since:
2007-07-18
I also noticed that when I
Tue, 09/11/2007 - 1:14pm

I also noticed that when I try dialing this number, it either rings for 30 seconds before asterisk even notices the call or it doesn't notice it at all and goes to my voice mailbox on vitelity.


&nbsp

shawnesc
Posts: 41
 Member Since:
2007-07-31
I have the same problem
Wed, 10/03/2007 - 7:09am

I have one of my SIP channels open all the time (it actually shows between 4 and 5 active channels) but using ASTassistant I see that there are 2 channels open and one phone "off the hook" when I "hang up" the channels they just come back again. Any ideas as to what is causing this? I did just update to FreePBX 2.3, so I am sure that that is the culprit (I had AST assistant before I upgraded with no such errors). Also, I am running TB 2.2.3, on an all VOIP network.

Thanks,
Shawn


&nbsp

shawnesc
Posts: 41
 Member Since:
2007-07-31
I just found this as a possible solution
Wed, 10/03/2007 - 7:20am

ja133
Posts: 394
Member Since:
2006-11-27
happened to me do this in
Tue, 09/04/2007 - 6:55am
new

happened to me

do this in root:

service asterisk restart
amportal restart

and you shouldnt see this problem

This worked for my problem , I still show 2 active channels , but only in TB Home page , and I have always seen them there. Using ASTassistant - all channels are now closed !


&nbsp

shawno66
Posts: 9
 Member Since:
2009-09-19
seemed to work for me
Wed, 01/13/2010 - 10:17am

I showed 11 active channels with no one on the phone.
I did the restarts as posted and now it shows 6.
This did seem to elminate our problem, which was dead air when calling over SIP.
We use NexVortex as our SIP provider.
Thanks!


&nbsp

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.