DEAR FRIENDS;
I installed trixbox and work fine with my ip phone and softphone.
but i have 2 questions?
1-i have 1 Quintum AS400 with 4FXO/4FXS PORT . IS it possible to config it for connect to trixbox and use of it 4 FXO ports as connecting PSTN TO Trixbox. ( PSTN----->TRIXBOX with Quintum).
2-how can config ATA186 for CONNECTING 2 fxs ports to trix box?
Regards
Mohammad Karaminejad
Student of I.T
Dear Mohamamd karam,
Have you configured your Quintum Gateway, firstly you have to configured it . then you have to define Inbound and outbound route & Trunk in which you will give the Gateway Address of Quintum .
Dear farrukh.nadeem
Thanks for your replay
I am not expert , really i am newbie; could you please discribe me more or give me some more details that i can work on it as a student.
Thanks
Students are supposed to study. Learn how to setup trunks and extensions.
The Quintum is just another SIP gateway,
There are many getting started guides in the wiki.
Scott
aka "Skyking"
Quintum supports codec (711, 723, 729), and can be configured be a SIP phone & trunk gateway, I used it with firmware P105 & P106 and talked with others.
Quintum configuration;
Set OIPR =1 (in Gateway-1)
Set PSIPS = TB's IP address ( SIPSignalingGroup-1)
Set OPS = TB's IP address ( SIPSignalingGroup-1)
For FXS connection, please
Add UserAgent (PU PPW and c[1])
*** if you add more UA, please don't use port 5061, it doesn't work ***
Set DN number of HLDND (HuntLDNDirectory-pub1)
For FXO connection, just add the SIP trunk and Rule
allow=all
host=aaa.bbb.ccc.ddd (Quintum's IP )
type=peer
hi friends,
any body has knowledge about to configure quintum dx2060 e1 to trixbox to accept incoming calls?
please help me on this,
thanks in advance.
suranga
Member Since:
2009-03-21