Home » Forums » Community Edition » Open Discussion

A very Good Question!! - never been answered well

cipherfx
Posts: 16
 Member Since:
2007-04-03
Submitted by cipherfx on Tue, 04/10/2007 - 12:38pm.

Could anyone please provide with maybe a list of things required in order to setup
dialing an outbound number via an extension. I'm only running sip via Teliax I have no phones etc.. I have unlimited phone lines. From what I understand there is a few mehtods. But which is the best /easiest method.

I can make incoming calls just fine.
I setup an outbound route, but I'm not sure if I did it right, then I also put a cell phone number with a 9 at the beginning under misc destinations. Is that all I need to do?
Thats what I've done so far but when I press 1 for that extension I get an error saying all circuits are busy. Any ideas or thoughts on this would be great. Or if anyone would like to remote into my machine and have a look that would be great. I'm just so new at this I'm trying to get a handle on it. I've read lots of tutorials but can't seem to find anything that is straight forward for this specific topic. I've looked through and through the fourms as well. Any thoughts ideas or links would be great. Thanks

- Nick
( CipherFX )

‹ TellMe Voice Recognition in Asterisk working.. server hang on after a few hours porblem ›

&nbsp

driver28
Posts: 171
 Member Since:
2006-06-05
Just tested this setup..
Tue, 04/10/2007 - 1:30pm

to get an answer for you...

My set up:

TB 1.2.3
X--lite 3.0
cell phone :)
I set up a Misc destination to dial my cellphone. Put the number in as I would dial it myself. I have working in and outgoing calls to start with. I put an option in my IVR to press 3 for my cellphone, call in and hit 3 in the IVR. My cellphone rings. Nothing more to it. I don't know if you consider this a good answer but that's abou all there is to it providing you have an otherwise working setup.

Hoe this helped a bit!

/Hasse

--

/Hasse


&nbsp

engjohn
Posts: 522
 Member Since:
2006-05-31
If you are getting "All
Tue, 04/10/2007 - 11:14pm

If you are getting "All circuits busy" then the most likely issue is that your outbound route and or outbound trunk are not setup or working properly.


&nbsp

cosmicwombat
Posts: 1173
 Member Since:
2006-05-31
Did you add...
Wed, 04/11/2007 - 5:09am

an # at the end of your cell phone number?

--

Robert Keller - Chief Technologist at large
The VoIP Experience
Open Telephony Training Seminar


&nbsp

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.