We are constantly plagued with the message 'all circuits are busy' this can happen a dozen times in a row before the call goes through, we use Gradwell. we have a 2mb link up and down.
Any ideas?
 
All Circuits are busy
Submitted by paul owen on Thu, 02/07/2008 - 3:00am.
Sounds like a router issue,
Thu, 02/07/2008 - 5:53am
Sounds like a router issue, verify that you have port forwards upd 10000-2000 and 5060 -5065 to your Trixbox IP, make sure your router has has set a static Internal IP for your server, then make sure your Trixbox has the right IP. command line>ifconfig to show current IP info. Also could be related to your Trixbox NAT settings, Check your SIP NAT.conf verify you have set an external IP address.
**Note, Disclaimer, I dont like the idea of forwarding all those ports, please read up on Trixbox security if the above solves the problem.
 
should that be 10000 to
Fri, 02/08/2008 - 3:42am
should that be 10000 to 20000 or 1000 to 2000 :)
 
my bad , your right, 10000-20000
Fri, 02/08/2008 - 11:12am
my bad , your right, 10000-20000
 
Member Since:
2008-02-07