Hi
I want to set up a Trixbox for our office, as we don't have an internet connection with QOS or a SLA I would like to kkep the lines on out local provider.
We have an ISDN connection through Swisscom with 2 voice channels. Which card do I need? I would like to go with a Digium card to maximize compatibility with Trixbox.
All the cards I can see are PRI 30 channel cards. Could someone help me out?
Sike
Sike,
Please check your PM. I have a product that I think will work quite nicely and is affordable.
Adam
- junghanns:
- quadBRI : HFC based 4 port BRI card
- octoBRI : HFC based 8 port BRI card
- AVM:
- fritz! pci (passive single BRI board)
- b1 PCI : 1 port active BRI card, known to work with chan_capi and chan_misdn, be sure to update the firmware here
- c2 : 2 port active BRI card, known to work with chan_capi
- c4 : 4 port active BRI card, known to work with chan_capi
- beronet:
- BN4S0 : HFC based 4 port BRI card, known to work with chan_misdn
- BN8S0 : HFC based 8 port BRI card, known to work with chan_misdn
- sirrix:
- PCI4S0: 4 port BRI card
- eicon:
- diva server BRI: active 1 port BRI card, requires kernel module: divadidd, known to work with chan_capi, voice and fax
- Diva Server V-BRI: active 1 port BRI card, requires kernel module: divadidd, known to work with chan_capi, voice only
- Diva Server 4BRI: active 4 port BRI card, requires kernel module: divadidd, known to work with chan_capi, voice and fax
- Diva Server V-4BRI: active 4 port BRI card, requires kernel module: divadidd, known to work with chan_capi, voice only
- Gazel:
- gazel 128 usb: 1 port BRI card uses hfc chipset, known to work with chan_misdn. Works on USB, so could be used on a laptop
-Digium
- Digium B410P: 4 ports BRI card. The B410P features on-board DSP-based echo cancellation and supports TE and NT mode over 4-wire S/T interface.
And of course the Sangoma A500 about which there has been no shortage of discussion in the Sangoma forum here at http://www.trixbox.org/forums/sangoma
Member Since:
2007-03-27