Home » Forums » Vendor Forums - Certified » Aastra endpoints

Use Tilt Base with 561M Sidecar

SkykingOH
Posts: 9541
 Member Since:
2007-12-17
Submitted by SkykingOH on Sat, 07/31/2010 - 2:11pm.

This is a completely unsupported modification. It is very simple and it works. This is on our operator console. If I was to do it at a customer site I would use a hacksaw to make the cuts neater.

Requirements:

  1. One fine tooth hacksaw
  2. Glue gun
  3. Q 2 Tilt bases

Install base as normal on phone. On sidecar remove material at top and bottom as required to prevent overlap. Remove plastic for key hole insertion on 561M that overlaps to host phone. Use hot glue at joint (not required but works best) as shown.


‹ BLF list with Astra 57i and Fonality Aastra 57i and 57i CT, Picking up calls placed on hold ›
--

Scott

aka "Skyking"



stechnique
Posts: 733
 Member Since:
2008-02-21
Nice, you should also glue
Sun, 08/01/2010 - 4:46am

Nice, you should also glue in a black plastic stick that goes the whole width at the bottom of the stands (where there's the rubber). Just glue it on top so the rubber still does its job, but then it would make sure both stands are the exact same inclination.



mcisar
Posts: 83
 Member Since:
2007-02-13
glad to know
Mon, 08/30/2010 - 10:31pm

Glad to know I'm not the only one who did the exact same "mod"... about 2 1/2 minutes after my first order of them arrived :-)

Cheers
>>>>> Mike


Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.