Does the 2.4 RC4 contain the required wanpipe RPM's for setting up an A102D? I have seen a few posts on the forums that 2.3.0.5 was the last supported version since the CentOS kernel was changed while moving to CentOS 5.1. (I know that I can install from source, but it is much easier with the RPM's)
I am anxiously awaiting the 2.4 release and was just curious how this was progressing...
Thanks,
Robert Jackson
The Wanpipe utils are current as of 2.3.0.11 so they will work fine now.
Kerry Garrison
http://www.VoipStore.com - http://3cxbook.com
(888) VOIPSTORE - (888) 864-7786
I'm trying 2.4.0.rc4 with the yummed version of the wanpipe drivers and the card is detected (A200D) but I can't get any calls in or out of the system. Exact same setup on the 2.3.0.7 version works fine. Should I wait for updated drivers or has anyone else run into this issue and gotten it resolved?
It looks like the setup-sangoma script isn't updating zapata.conf or zapata-auto.conf
Issue resolved itself
I ran a amportal stop, then wanrouter stop
Ran a wanrouter start, then a ztcfg -vvv to make sure all the ports were detected
Then ran amportal start and everything is working now.
I guess I zigged when I should have zagged?
Actually the phones ring but I can answer but no audio is passed. BAck to the drawing board
remove "echotraining=800" from zapta.conf and reboot... everything will be fine.
at least it was for me...
echo training was already removed
It works for a while and then quits
What version of trixbox do you have on your machine?
Copyright © 2011 Fonality
Fonality and trixbox are trademarks of Fonality. Trademark Policy. Privacy Policy.
Asterisk is a trademark of Digium, Inc. Fonality and trixbox are not affiliated with, nor endorsed by Digium, Inc.
Member Since:
2007-04-13